Kaltech Global News Centre

August 22nd, 2017 | Categories: News

Increasing Reline Safety and Efficiency With New Mill Reverse Plugs

Increasing Reline Safety and Efficiency With New Mill Reverse Plugs

PROJECT FOCUS

• Reduce the safety risk of pinch points
• Use the correct tool for the job
• Increase reline efficiency and reduce maintenance downtime by using redesigned plug to be installed from the inside

Click here to see the results of the […]

Read more →

September 29th, 2015 | Categories: News

Greg Kingdon, of Kaltech, Presents at SAG Conference

The Eyes Have It: Improving Mill Availability Through Visual Technology

At the 2015 SAG Conference Greg Kingdon of Kaltech Global presented on recently developed tools that allow for greatly enhanced performance and monitoring of SAG/AG Mills.

This paper describes the introduction of two unique tools that discard the longstanding notion that it […]

Read more →

October 29th, 2013 | Categories: News

Kaltech Featured in Mining Magazine October 2013 Issue

A Job for Experts

In this article, see full Kaltech Mining Magazine article here, Greg Kingdon of Kaltech International explains why it is so important to engage a professional mill relining company from the time a concentrator is designed

Read more →

September 29th, 2013 | Categories: News

Kaltech Pivotal in Reducing Mill Maintenance Down Time at Escondida

Reducing Down Time Boosts the Bottom Line for Esconidia

Featured in “Productivity Review” was this co-project between Kaltech and Esconidia. With Kaltech’s guidance and help the operation was able to shave down time on its Mills by 3.5%, resulting in an income boost of roughly $35 Million!

Here is an excerpt from […]

Read more →